Connecting your in-person audio device

When dialing in, you will take these steps to properly connect your audio mixer or conferencing system:

-Dial the public meeting phone number shown on the meeting page

-Input the four-digit meeting ID (if you are not using a pin-free line)

-After the prompt, press * 9 to access the admin menu

-Input your admin pin (located in the meeting admin interface):

After putting in your admin pin, the line will now be in the meeting as an un-muted admin connection.

Mute/Unmute Room Audio flowing into the bridge

You can mute this line by pressing * 6.

You can un-mute this line by pressing * 7.

You can also mute, unmute, or disconnect this line from your meeting admin interface:

Return to the hybrid public meeting table of contents.

Did this answer your question?